The study investigated the effects of the addition of starch on the properties of oil palm biomass particleboard bonded with citric acid. Three kinds of oil palm biomasses were used in this study for the fabrication of particleboard, namely, oil palm frond (OPF), oil palm trunk (OPT), and empty fruit bunch (EFB) particles. Citric acid and tapioca starch at the mixing ratios of 100:0, 87.5:12.5, and 75:25 was prepared at a 60% solid content. A 30% resin content based on the oven-dried weight of the oil palm biomass particles was used. The sprayed particles were pre-dried at 80 ◦C for 12 h before being hot-pressed at 180 ◦C and 4 MPa pressure for 10 min. The physical and mechanical properties of the particleboard were evaluated. The mixtures of citric acid and tapioca starch were characterized by thermogravimetric analysis (TGA). Thermal stability of citric acid was reduced after the addition of tapioca starch. The addition of 12.5% tapioca starch improved the bending strength of the particleboard but increased the thickness swelling slightly. All UF-bonded particleboard exhibited significantly inferior performance than that of citric-acid-bonded particleboard. Citric-acid-bonded particleboard maintained its original shape after being subjected to a cyclic-aging treatment, while the UF-bonded particleboard disintegrated half way through the treatment. The performance of EFB particleboard was significantly inferior to its OPT and OPF counterpart. In term of termite and fungi resistance, citric acid-bonded particleboard exhibits better resistance compared to that of UF-bonded particleboard.
Lee Seng Hua earned his PhD in Wood Science and Technology at Faculty of Foretsry, Universiti Putra Malaysia. Following graduation, he continued his academic career as a post-doctoral researcher at Faculty of Forestry, Universiti Putra Malaysia for 3.5 years. He is currently employed as a research fellow at the Institute of Tropical Forestry and Forest Products, Universiti Putra Malaysia. His research has focused primarily on value-added composite panel technology, bio-based adhesive and non-wood materials such as bamboo and oil palm.
Share this page on your timeline